Ustening to radio broadcasts, Using the sleep timer, For better reception – Panasonic RX-DT770 User Manual
Page 16: Press fm mode/bp, Press sleep to select the desired time, To release the timer function, To check the time remaining during operation, To change the time remaining during operation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Ustening to Radio Broadcasts
Using the Sleep Timer
-TUNING +
oo
For better reception
When there is too much interference during an
FM stereo broadcast
{Available only from the remote control)
Reduce the interference by setting the sound to monaural.
FMMODE/BP
Press FM MODE/BP.
Lights
To return to stereo reception, repeat the same procedure and turn
off the MONO display.
(Available only from the remote control)
The unit off time can be set up to two hours ahead of the present
time.
•Sl£EP/-DEMO
While the unit is on;
Press SLEEP to select the
desired time.
0:30
1:00 ^ 1:30 ^ 2:00 -> OFF
[-»
3
(The display changes each time the but
ton is pressed.)
S L E E P D-30
The unit is turned off after the time set
has elapsed.
The Kiia:iaw display will not light in the monaural mode even
when a stereo broadcast is received.
Adjusting the antenna for better reception
FM
Pull out the telescopic antenna and adjust its length and angle for
optimum reception.
AM
Turn the unit in the direction which gives the best results.
Reference
Radio broadcasts may be hard to receive in a moving vehicle or
building because their signals are weak. Whenever possible, use
the unit by a window.
To release the timer function:
Press SLEEP to select "SLEEP-OFP.
To check the time remaining during operation:
Press SLEEP.
To change the time remaining during operation:
Press SLEEP to show the remaining time then press SLEEP to
select the desired time.
Pressing SLEEP can turn the unit on (only when AC power is sup
plied).