Yamaha HTR-5830 - Manual (Page 28)

PLAYBACK
1
Press STANDBY/ON (or SYSTEiW POWER on
the remote control) to turn on the power.
SYSTEM
POWER
Front panel Remote control
2
Turn on the video monitor connected to this
unit
3
Press SPEAKERS A/B/OFF on the front
panel to select the front speakers you want
to use.
SPEAKERS
A/B/OFF
Press INPUT <1 / o repeatedly (or one of the
input selector buttons on the remote control)
to select the input you desire.
The selected input source name and input mode
appear on the front panel display for a few seconds.
<} lIMPUT P»
Front panel
CD MD/CD-R TUNER
o o o
DVD D-'FV/CBL VCR V-AUX
sO O O
Remote control
VCR V-AUX DTV/CBJ. , DVD , MD/C&R TUNER CD
.DUD. PUTO,
Selected input source Input mode
5 Start playback or select a broadcast station
on the source component.
Refer to the operation instructions for the
component.
6 Adjust the volume to the desired level.
Front panel Remote control
If desired, use TONE CONTROL and
BASS/TREBLE
-!+. These controls only effect the
sound from the front speakers.
TOME COPJTfiOL BASS/TREBLE
Front panel
w/
Notes
• If you increase or decrease the high-frequency or the low-
frequency sound to an extreme level, the tonal quality from the
center and surround speakers may not match that of the front
left and right speakers.
• If you have connected a recording component to the VCR
OUT. or MD/CD-R OUT jacks, and you notice distortion or
low volume during playback from other components, try
turning oil the recording compoiieiit.
24