Yamaha HTR-5830 - Manual (Page 38)

TUNING
There are 2 methods of tuning; automatic and manual.
Automatic tuning is effective when station signals are
strong and there is no interference.
Automatic tuning
4
Press PRESET/TUNING <i / o once to begin
automatic tuning.
Press O to tune in to a higher frequency, or press <1
to tune iti to a lower frequency.
■O PRESET/TUNING C>-
ifíSíiOfl
4 1
1
Press iNPUT o /1> (or TUNER on the remote
control) to select TUNER as the input source.
IIVPUT &■
Front panel Remote control
2
Press FM/AM to select the reception band.
"FM” or “AM” appears on the front panel display.
FM/AM
e
C Ivi iM
Press TUNING MODE (AUTO/MAN’L MONO)
so that the “AUTO” indicator lights up on the
front panel display.
TUNING MODE
(Qs
AUT0/U;sN'
AUTO
Lights up
If the colon (:) appears on the front panel display,
tuning is not possible. Press PRESET/TUNING
(EDIT) to turn it off.
PRESET/TUNING
”0
- SÍTMENU 4-
♦
VCR V-AUX DWyCBL DWi
When the unit is tuned in to a station, the “TUNED”
indicator lights up and the frequency of the station
received is shown on the front panel display.
■ Manual tuning
If the signal from the station you are trying to select is
weak, tune in to it manually,
1
Select TUNER and the reception band
following steps 1 and 2 described in
“Automatic tuning” at left.
2
Press TUNING MODE (AUTO/MAN’L MONO)
until the “AUTO” indicator disappears from
the front panel display.
TUNING MODE AUTO
Disappears
If the colon (:) appears on the front panel display,
tuning is not possible. Press PRESET/TUNING
(EDIT) to turn it off.
PRESET/TUNING
VCR V-AUX DTV/CBl DVD
Press PRESET/TUNING
<l /1> to tune in to the
desired station manually.
Hold down the button to
continue searching.
■<] PRESET/TUNING O-
Note
• Manually tuning in To an FM station will automatically change
the reception inode to monaural to increase the signal quality.
34