Sound 2 sp distance, Speaker distance), 1 press/\/\/to select “unit – Yamaha HTR-5830 User Manual
Page 47: 3 press /\ / nv to select a speaker, 4 press < / > to set the distance, Sounds lee level, 1 press /\ / w to select the item to be adjusted, 2 press < to adjust the lfe level, Note, Sdund 4 d. range
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SETMENU
SOUND 2 SP DISTANCE
(speaker distance)
Use this feature to manuall}' input tlie distance of each
speaker and adjust the delay applied to respective
channel. Itleally, each speaker should be the same
distance from the main listening position. However, this is
not possible in most home situations. Thus, a certain
amount of delay must be applied to the sound from each
speaker so that all sound will arrive at the listening
position at the same time.
1
P r e s s / \ / \ / t o select “UNIT”.
2
Press < / > to select the unit “meters” or
“feet” to be used in setting.
3
Press /\
/
Nv to select a speaker.
4
Press
< / >
to set the distance.
Press > for higher values and < for low'er values.
SOUNDS LEE LEVEL
I Ue to adjust the output level of the LFE (low'-frequency
effect) channel according to the capacity of your
subwoofer or headphones. The LFE channel carries low-
frequency special effects which are only added to certain
scenes. This setting is effective only when this unit
decodes Dolby Digital or DTS signals.
Control range:
SP LFE"(Speaker)...............-20 to 0 dB
HP LFE (Headphone)......... -20 to 0 dB
Initial setting: 0 dB
1
Press /\ / w to select the item to be
adjusted.
2
Press < to adjust the LFE level.
Note
• Adjust the LFE level according to the capacity of your
subw'oofer or headphones.
SDUND 4 D. RANGE
(dynamic range)
Use this feature to adjust the dynamic range. This setting
is effective only wdien the unit is decoding Dolby Digital
signals.
Choices:
MAX
(maximum), STD (standard),
MIN (minimum)
MAX
Select MAX for feature films.
■ Setting by “meters”
Control range:
0.30 to 24.00 m (for front L/R, center,
surround L/R)
Initial settings; 3.00 m (for front L/R, center,
surround L/R)
■ Setting by “feet”
Control range:
1.0 to 80,0 ft (for front L/R, center,
surround L/R)
Initial settings:
10.0 ft (for front L/R, center,
surround L/R)
Note
• No delay wHI be set if you set the same distance for the front
L/R and center, or the surround L/R,
STD
Select STD for general use.
MIN
Select MIN for listening to sources at lowf volume levels.
43