Yamaha MT100II - Manual (Page 25)

SPECIFICATIONS
TAPE TRANSPORT
Tape Type
Heads
Tape Speed
Pitch Control
Wow & Flutter
Rewind Time
Motor
Chrome (70 microsec. EQ)
4-channel Permalloy rec/play head
4-channel ferrite erase head
4.8 cm/sec., 9.5 cm/sec.
± 10%
Less than 0.15% WRMS
Approx. 100 sec., for C-60 tape
DC servo motors (2)
CONNECTORS
Input 1 — 4 Input Impedance 10 k-ohms
Rated Input Level -10 dB to -50 dB (fader nominal)
Max. Input Level +10 dB (gain control min.)
Min. Input Level -56 dB (gain control, fader max.)
AUX RETURN L & R Input Impedance 10 k-ohms
Rated Input Level -10 dB (AUX RETURN level control nominal)
Min. Input Level -16 dB (AUX RETURN level control max.)
STEREO OUT L & R Output Impedance 1 k-ohm
Load Impedance Greater than 10 k-ohms
Rated Output Level -10 dB into 50 k-ohms
PHONES Load Impedance 8 to 40 ohms
Max. Output Level 45 mW + 45 mW/40 ohms
TAPE OUT 1 — 4 Output Impedance 1 k-ohm
Load Impedance Greater than 10 k-ohms
Rated Output Level -10 dB into 50 k-ohms
AUX SEND Output Impedance 1 k-ohm
Load Impedance Greater than 10 k-ohms
Rated Output Level -10 dB into 50 k-ohms
MONITOR OUT Output Impedance 1 k-ohm
Load Impedance Greater than 10 k-ohms
Rated Output Level -10 dB into 50 k-ohms
ELECTRICAL SPECIFICATIONS
Frequency Response (NR OUT) 50 Hz to 18 kHz, +3 dB/—6 dB at 9.5 cm/sec.
50 Hz to 12.5 kHz, +3 dB/-6 dB at 4.8 cm/sec.
85 dB, dbx ON, IHF-A
1.5% at 315 Hz, dbx on, —10 dB Rec, Level
Greater than 55 dB at 1 kHz, dbx on
Greater than 70 dB at 1 kHz, dbx on
dbx *
100, 400, Ik, 5k, 10kHz (± 10 dB), 0 = 0.7
S/N ratio (3% THD Level)
Distortion
Channel Separation
Erasure Ratio
Noise Reduction
Graphic Equalizer
GENERAL
Power Requirements
(PA100 AC Adaptor)
Dimensions (WxHxD)
Weight
U.S. & Canadian Models: 120 V AC, 60 Hz
General Model: 220/240 V A C , 50/60 Hz
400 X 7 6 x 2 1 2 m m (15-3/4” x 3" x 8-3/8")
2.0 kg (4 lbs 7 oz)
* dbx is a trademark of dbx Incorporated.
OdB = 0.775 Vr.m.s.
All specifications subject to change without notice.
23