Yamaha RX-V663 - Manual (Page 40)

Optimizing the speaker setting for your listening room (YPAO)
15 Press (DENTER to confirm your selection.
The top “SET MENU” screen appears in the OSD.
SET MENU
^ -fiUTO SETUP
■hflNUflL SETUP
■ SIGNAL INFO
C A ] / [ T ] : U p / D o w n
[ENTER]:Enter
16 Press (iiMENU to exit from “SET MENU”.
If you change speakers, speaker positions, or the layout of your
listening environment, run “AUTO SETUP” again to recalibrate
your system.
■ If “WARNING” appears
When this unit detects potential problems during the
“AUTO SETUP” procedure, “WARNING” appears in the
top result display. Check the warning messages to correct
your speaker settings.
Not 0
Warnings differ from errors in that warnings do not cancel the
“AUTO SETUP” procedure.
1
Make sure the pointer is pointing at
“WARNING” and then press (DENTERto
display the detailed information about the
warning.
The number on the right of “WARNING” indicates
the number of warning messages.
If an error screen appears
Press d)/^ / V / <3 /1> to select “RETRY” or
“EXIT” and then press ©ENTER.
The following display is an example when “E-9:USER
CANCEL” appears in the OSD.
AUTO SETUP
^ WARNINGS.3>
RESULT
SP : 3/4/0.1
DIST: 14.0/17.0ft
LUL : -9.0/+6.5dB
>SET CANCEL
[A]/[T]:lJp/Down
[ENTER]:Detail
ERROR
^ E-9:USER CANCEL
Don’t operate
any function
Press
® <3 /1>
repeatedly to toggle between
the warning displays.
>RETRV EXIT
[^]/[N-]: Select
[ENTER]:Enter
Choices:
RETRY,
EXIT
• Select “RETRY” to retry the “AUTO SETUP”
procedure.
• Select “EXIT” to exit from the “AUTO SETUP”
procedure.
If “E-5:NOISY” appears, “PROCEED” also appears in the
choices. When you select “PROCEED”, this unit continues the
measurements and settings, but the settings may not be optimal.
UARNING
W-l:0UT OF PHASE
Reverse Channel
FL —
CENTER
PL PR
SL SR
SBL SBR
[-^]/[N-]:Select
[ENTER]:Return
' For details about each warning message, see the “AUTO
SETUP” section in “Troubleshooting” on page 117.
• When the corresponding warning message is not
applicable to a speaker, “—” is displayed instead.
► If “SWFR: TOO LOUD” or “SWFR: TOO LOW” appears
in the “W-3: LEVEL ERROR” display, adjust the volume
level of the subwoofer(s).
Press (D ENTER to return to the top result
display.
36
En