Yamaha RX-V663 - Manual (Page 91)

Customizing this unit (MANUAL SETUP)
Bass cross over CROSS OUER
Use this feature to select the crossover frequency of all the
speakers set to “SML” (or “SMALL”) in “SPEAKER
SET’ (see page 85). All frequencies below the selected
frequency will be sent to the subwoofer(s) or front
speakers depending on the setting of “LFE/BASS OUT’
in “SPEAKER SET’ (see page 85).
Choices: 40Hz, 60Hz,
80Hz,
90Hz, lOOHz, 1 lOHz,
120Hz, 160Hz, 200Hz
If your subwoofer can adjust the output volume and the crossover
frequency, set the volume to about half way (or slightly less) and
set the crossover frequency to the maximum.
Subwoofer phase SUBWOOFER PHASE
Use this feature to switch the phase of your subwoofer if
bass sounds are lacking or unclear.
ft)SPEAKER SET
SLIBUiOOFER PHASE
>NCiRMAL REUERSE
" V ; ■ 1
NORMAL
(normal) Does not change the phase of your subwoofer.
REVERSE
(reverse)
Sets the phase of your subwoofer to reverse.
■ Speaker level B>SP LEUEL
Use this feature to manually balance the speaker levels
between the front left or surround left speakers and each
speaker selected in “SPEAKER SET” (see page 85).
Control range: -10.0 dB to +10.0 dB
Control step: 0.5 dB
Initial setting:
FR.L/FR.R/SWFR/PR.L/PR.R: 0 dB
CNTR/SUR.L/SUR.R/SBL/SBR: -1.0 dB
B)SP LEUEL 1/2
FR.L “»»-II-
FR.R .... II-
CHTR .... I-
SUR.L.. I-
SUR.R.. I-
B)SP LEUEL 2/2
SBL
SBR
S1..JFR
SI^UEVEL
5
iili«
FR.L Front left speaker
FR.R Front right speaker
CNTR Center speaker
SUR.L Surround left speaker
SUR.R Surround right speaker
SBL Surround back left speaker
SBR Surround back right speaker
SWFR Subwoofer
PR.L Presence left speaker
PR.R Presence right speaker
• If your subwoofer can adjust the output volume and the
crossover frequency, set the volume to about half way (or
slightly less) and set the crossover frequency to the maximum.
• Set “TEST TONE” to “ON” to output the test tone for the
“SPEAKER LEVEL” setting (see page 88).
• The available speaker channels differ depending on the setting
of the speakers.
* Instead of “SBL” and “SBR”, “SB” is displayed if “SUR. B L/R
SP” is set to either “SMLxl” or “LRGxl” (see page 86).
87 En