Panasonic TC-34P250X - Manual (Page 19)

Picture Menu
C.TEMP
(Colour Temperature)
Allows you to set the overall colour tone
of the picture.
Press ^ or ^ to switch between modes
- S T A N D A R D W A R M COOL-
[T
mKsmmmi'ismirimsim
—P—T S
P-NR
(Picture Noise
Reduction)
Automatically reduces unwanted picture noise.
Press ^ or ^ to switch between modes
OFF <-------- > STRONG
i:^
AUTO-^ ■^WEAK
TC-29P250H»TC-34P250H switching is also
possible using on the remote conttol
Al Automatically analyses the incoming
picture and processes it to give improved
contrast and optimum depth of field.
TC'29P250H,TC-34P250H switching is also
possible using ^ on the remote contloi
SCAN MODE Lets you choose the screen refresh method:
Press ^ or ^ to switch between modes
-AUTO-^->-100 Hz MODE <-> PROGRESSIVE- :i]
MODE Function
AUTO The TV software will select the best mode for the signal being viewed.
100 Hz MODE 100Hz will give a steady picture for most signal transmission.
PROGRESSIVE Recommended when receiving NTSC signals.
Swtiching is also possible using on the remote control.
Note:
• We recommend that you set Scan mode to Progressive when viewing a PAL 60
or NTSC transmission. When viewing a PAL transmission (other than PAL 60)
with Scan mode set to Progressive, the screen will flicker, this is not a fault.
f Helpful Hint (ESlNormalization)
By pressing the Normal “N” Button on the Remote Control while the Picture menu is displayed, the selected menu w’ll be changed to
the Normal Mode.
Normalization will not occur if the menu is not displayed when the "N" Button is pressed.
The Normal mode is the factory preset condition. Returning to this original condition is called “Normalization".
19