Panasonic TC-34P250X - Manual (Page 27)

Tuning Menu
Manual tune
Before Auto tune, set the “SYSTEM SELECTION” and “CHANNEL SELECT” mode.
SETUP
or Mm
1 Press ^
2 Move to chosen menu option by using or
3 Access Tuning menu by using ^ or
4 Move to chosen menu option by using
5 Access Manual Tune by using ^ or
6 Select the programme position to be tuned by using
7 Press repeatedly until required station Is found by using
STR
When the desired station is found, press ® to store.
The program position will flash.
TOW
Press ® at any time to go back to watching TV.
or
or
Manual tune (via front panel)
It is also possible to use the control panel buttons on the front of the TV to tune individual programme positions
1 Press ■ (Front panel) until Tuning mode is reached.
2 Press or H to access Tuning mode.
3 Press to move between Change programme, Search and Change TV
system.
4 Press
-/V +/A
to change programme position or start search.
When the desired station is found, press M to store.
The programme position will flash.
Repeat above procedure to tune additional programme positions.
Press (! at any time to exit the Tuning menu.
F
t'Helpful Hint
1. If a clear picture cannot be obtained even when a Broadcast or AV signal is received, refer to the "Colour System Selection”
operation on page 25.
2. After the Manual tune is finished, press the Programme Number “Up” Button to confirm the tuning condition for each Programme
Numbers. If some Programme Numbers are unused, it is possible to skip such Programme Numbers.
3. When using a VCR without video and audio input/output terminals, it is convenient to connect the aerial cable as indicated in the
instruction manual of VCR and to set the designated channel to programme No.“0”. In that case, perform manual tune after
setting the colour system and sound system in advance. Further, in multi-system VCR, it is more convenient to set the designated
channel to several programme Numbers.
27