Panasonic TC-34P250X - Manual (Page 28)

Aspect Controls
Press to move through the aspect options:
->4:3--------------- >16:9-^
AUTO<- ■S-ZOOM i<—^
Notes:
ASPECT
• Simply press g to display mode infbrmafion in the top left of the screen.
> 16:9 picture has been used to illustrate all of the aspect modes described in this section.
• During AV mode, AUTO is added to the options displayed above.
The on screen selector keys (corresponding to the four coloured buttons on the remote control) that appear for some
ASPECT
Aspect functions clear after a few seconds. If you want to select an operation when the keys are not shown, press ^
once more and the keys will reappear.
Mode Picture Explanation
AUTO When a wide screen signal from the special video is
detected by S1-Video Terminal of the unit, the Aspect
ratio auto-matically set to 16:9 screen.
There is a wide variety of software avaitaUe with aspect
ratios from 1.78:1 (16:9) to 2.35:1 (cinema vision).
4:3 4:3 will display a 4:3 picture at its standard 4:3 size
without any stretching.
S-ZOOM H--------- 4-------------1
"O'
Zoom
i
S-Zoom displays the picture at a greater magnification
than Zoom mode does.
Press the red or green buttons to move the picture
horizontally. Press the yellow or blue buttons to move
the picture vertically.
Blue button has been
p r e s s e d t o m o v e
picture upwards
1 6 : 9 16------------ 1 16:9 will display the picture at its maximum size but
with slight stretching. Black stripes will be visible down
the top and bottom of the picture.
28