Panasonic TC-34P250X - Manual (Page 26)

Tuning Menu
Auto tune
Before Auto tune, set the “SYSTEM SELECTION” and "CHANNEL SELECT” mode.
SETUP
1 Press ^
2 Move to chosen menu option by using or
3 Access Tuning menu by using ^ or
4 Move to chosen menu option by using or .
5 Access AUTO TUNE by using or
Notes:
• If you proceed with the next step all tuning data will be erased (all stations
and their programme positions stored In your TV’s memory will be wiped out
so the new settings can be stored).
• If you exit the procedure after this point and before AUTO TUNE is
complete, no station information will be stored. Restart and complete
the AUTO TUNE procedure so that the TV is re-tuned.
6 Start AUTO TUNE by using ^ or
Once this operation is completed the TV will display the program now stored
on programme position 1.
TWKV
Press © at any time to go back to watching TV (please read the Note
in the above procedure).
Auto tune (via front panel)
It is also possible to use the control panel buttons on the front of the TV to tune individual programme positions
1 Press (Front panel) until Tuning mode is reached.
2 Press ^ or to access Tuning mode.
3 Press M (Front panel) to access Auto tune.
4 Press ^ or ® to start search.
When the desired station is found, press P to store.
STR
The programme position will flash.
Repeat above procedure to tune additional programme positions.
Press P at any time to exit the Tuning menu.
f
Helpful Hint
1. If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, refer to the "Colour System
Selection" operation on 25.
2. After the Autemiatic tune is finished, press the Programme Number “Up" Button to confirm the tuning condition for each Programme
Number. If some Programme Numbers are unused, it is possible to skip such Programme Numbers. Please refer to the Programme.
26