Channel Vision DVR-8N - Manual (Page 41)

-
MENU SETUP
Change the value of the HORIZONTAL
mouse to adjust the horizontal position of the screen.
POSITION using the (-), (+) buttons or wheel scroll of
to +4 and the default is “0”.
heel scroll of mouse
.
t
Move the cursor to the AUTO SEQUENCE using © or ª buttons.
Press the ENTER button when the cursor is on the AUTO SEQUENCE and the following 4 pages
Move the cursor to each single or split channel using the § , ¨ buttons.
When the desired channel is selected, change the value of AUTO SEQUENCE duration using
the (-), (+) buttons or wheel scroll of mouse to set the length of time for switching each channel in
sequence.
* The value is from 0SEC to 60SEC and the default is “3SEC”.(Not suggest to select 0SEC)
To exit this AUTO SEQUENCE menu, press the ESC button.
* The value is from -4
Change the value of the VERTICAL POSITION using the (-), (+) buttons or w
to adjust the vertical position of the screen.
* The value is from -4 to +4 and the default is “0”.
To exit this POSITION menu, press the ESC button.
6 2.2 AUTO SEQUENCE
A the SCREEN menu,
screen appears.
ADD AUTO SINGLE: If selected OFF, every single channel will be skipped in the AUTO SEQUENCE mode.
The default is “OFF”.
Note: You can select 0 sec to Skip the auto-split type, but the quad-A the most basic split function,
so quad-A the smallest split value is 1.
40