Panasonic SC-CH950 - Manual (Page 28)

Listening to Radio Broadcasts
(continued)
Manual memory presetting
When this method is used, you can freeiy preset .stations to any
desired channel.
You can preset FM stations in monaurai position. (See page 26.)
(Steps 1 and 4 also available from the remote control)
1
Press BAND to select FM or MW or LW.
Each time you press BAND, “FM”, “MW”, “LW” wiii appear in
order.
2
Press one of TUNING to tune to the desired
broadcast.
(See “Automatic scanning” right.)
Each time you press one of TUNING, the frequency display
will change as follows:
FM; 0.05 MHz step
MW; 9 kHz, 10 kHz step
LW: 9 kHz
3
Press MEMORY momentarily.
MEMO indicator will illuminate.-------------
T m O O ri n
I 1 1 U U . U U
I^VCR WU»«
OUMT Loa(| >■ ■“
»X~ = -
The channel indicator will flash.
4
Press one of PRESET to select the desired
preset channel.
I^vot
^ n n n n
r n i O U . U
"l
” 1
VOUM
L MM
ft S mm
MMANCS
1
Frequency Preset Flashing
channel
5 Press MEMORY momentarily.
Once the desired station has been memorized, MEMO indica­
tor will no longer illuminate.
The channel indicator will stop flashing.
■ Automatic scanning
You can make an automatic tuning using TUNING.
Press and hold one of TUNING until the displayed
frequency begins to change.
T TUHIHQ t
c
The changing of the displayed frequency will be automatically
stopped if a broadcast station frequency is located during the tuning
process.
To cancel the automatic scanning, press one of TUNING once
again.
When there is excessive interference, the automatic scanning may
not function.