Panasonic KX-F280C - Manual (Page 140)

For Users in Canada
SAFETY PRECAUTIONS
This unit may only be connected to electrical
outlets that supply 120 V AC.
NOTICE:
The Canadian Department of Communications
label identifies certified equipment. This
certification means that the equipment meets
certain telecommunications network protective,
operational and safety requirements. The
Department does not guarantee the equipment will
operate to the user’s satisfaction.
Before installing this equipment, users should
ensure that it is permissible to be connected to the
facilities of the local telecommunications company.
The equipment must also be installed using an
acceptable method of connection. In some cases,
the company’s inside wiring associated with a
single line individual service may be extended by
means of a certified connector assembly
{telephone extension cord). The customer should
be aware that compliance with the above
conditions may not prevent degradation of service
in some situations.
Repairs to certified equipment should be made by
an authorized Canadian maintenance facility
designated by the supplier. Any repairs or
alterations made by the user to this equipment, or
equipment malfunctions, may give the
telecommunications company cause to request the
user to disconnect the equipment.
Users should ensure for their own protection that
the electrical ground connections of the power
utility, telephone lines and internal metallic water
pipe system, if present, are connected together.
This precaution may be particularly important in
rural areas.
CAUTION:
Users should not attempt to make such
connections themselves, but should contact the
appropriate electric inspection authority, or
electrician.
The Load Number:
(found on the rear side of the unit)
(LN) assigned to each terminal device denotes the
percentage of the total load to be connected to a
telephone loop which is used by the device, to
prevent overloading. The termination on a loop
may consist of any combination of devices subject
only to the requirement that the total of the Load
Numbers of all the devices does not exceed 100.
This digital apparatus does not exceed the Class B
limits for radio noise emissions from digital
apparatus as set out in the interference-causing
equipment standard entitled “Digital Apparatus”,
ICES-003 of the Department of Communications,
If there is any trouble, disconnect the facsimile
from the telephone line, and connect a known
working phone. If the known working phone
operates properly, have the defective unit repaired
by one of the specified Panasonic Factory
Servicentres {refer to your dealer). If the known
working telephone does not operate properly,
consult your telephone company.
8-6