Panasonic SCAK50 - Manual (Page 20)

Recording from radio broadcasts
Press DECK 2 ± OPEN, and then insert the tape.
Close the holder by hand.
Tape direction is automatically set to
Press DOLBY NR.
You have to turn Dolby NR ON/OFF according to the type ot
recording you want to make.
Every time you press the button; r-.T-f
^ p DP NR — OFF -|
Press REV MODE to select the reverse mode.
Every time you press the button;
- - CZ5
C
J
□
^ ; One side is recorded, then recording stops auto-
matically.
: Both sides (front side ' reverse side) are recorded,
then recording stops automatically.
Select a radio station. Perform steps 1 through 3 on
page 18.
Press • REC/STOP to start recording.
If you selected in step 3, the direction will automaticallv
change to ^3 when recording starts.
To stop recording
Press • REC/STOP again.
Recording can also be stopped by pressing ■.
To start recording on reverse side
Load a tape and change the tape direction as explained here below,
1, Press TAPE DECK 1/2 and select tape deck 2.
2. Press and immediately thereafter ■. The tape direction will be
shown as
To record from a specific point on a tape
Before recording, advance the tape to the point from where you want
to start recording.
To cut an unnecessary part while recording
1, Press • REC/STOP when hearing an unnecessary part. The cassette
deck will go into the stop mode.
2. Press • REC/STOP when wanting resume recording again.
Recording will continue in the same direction as before.
When recording an AM broadcast, volume is momentarilv interrupted
when you start and stop the recording.
To reduce the noise while AM recording
(Beat proof function) O
Press FM MODE/BP while recording.
Each time you press the button, "BP 1" and "BP 2" will be displayed
alternately.
Select the position where there is less noise.