Panasonic SCAK50 - Manual (Page 9)

Presetting radio broadcasts
%\\ \ ^ / ///
)“ H A J~( ~l r J”L,
t" t ) )_l I. _l i^r
iü I #//
i^Mñj
GaFi
IwH Nt I I It II
I I ("i III i_i |■■( I
Preset channel
'j‘“‘tl L.,
lUJ
1 t 1
1 t i
tt m-.
\\V V
i:.
S.'
-j
t
J_U ■V.- C
n ¡\ A l”( l~ ( 1 luu.
PRGM , 1 1
^ ^ ^ WH í
/MBR i I
Station
VuTi
Up to 12 stations can be set in each band with the automatic oi
manua! memory presetting.
If broadcast frequencies are preset in the memory, vou can easilv
tune in any of these frequencies from the system or remote control
unit.
You can preset just those stations you tike. (See "Presetting only
your favorite stations" below.)
1 Press TUNER BAND to select band.
The power will come on automatically.
Every time you press the button; FM + AM.
Press TUNE MODE to select “MANUAL”.
Every time you press the button; MANUAL PRESET,
Press V or A until the display shows the frequency
from which you want to begin automatic memory
presetting.
Tips on tuning in radio stations
® Hold down either arrow button until the frequency numbers
start scrolling.
(2) When near to the frequency you are looking for, press the
button repeatedly until tuning the broadcast in.
Press and hold MEMORY/SET until the frequency
begins to change.
This will start presetting automatically. When finished, the radio
will tune in last station memorized.
If auto presetting is not possible because radio signáis are weak
or for some other reason, do the following.
Presetting only your favorite stations
Preset the stations one at a time.
1. Perform above steps 1 and 2. Then, select a station with V and
A, and press MEMORY/SET. "PRGM" will flash on the display.
2. While "PRGM" is flashing, select a preset channel with V or A,
and press MEMORY/SET againi "PRGM" will go out and the station
will be stored in memory.
Memory retention
Your preset frequencies are retained in memory for about 2 weeks
while the system is unplugged.
AM allocation settings:
This system comes equipped with an electronic digital tuner that
divides the broadcast band into many small steps. These steps match
the assignable broadcast frequencies and intervals in between.
Each country allocates broadcast bands according to their particular needs.
By adjusting the allocation, you can enable the tuner to receive AM
broadcasts allocated in 10 kHz steps.
1. Press TUNER BAND to select AM.
2. Press and hold TUNER BAND. As the flashing display will show
the minimum frequency of the AM band after 5 seconds, continue
to hold TUNER BAND for 5 more seconds.
3. When the display stops flashing and indicates a different frequency
number, release TUNER BAND.
To return to the original frequency indication, repeat steps 1 to 3
above.
GES
After changing the "allocation" setting, the frequencies you pre\ iously
preset in the memory will be cleared.