Panasonic SCAK50 - Manual (Page 29)

Using the record ftmar
To switch the timer OFF; Q
Press ©PLAY/0REC and check "©REC" goes out.
If you set the timer wrongly Q
Press ©PLAY/®REC so that "0REC" goes out. Then, repeat the
procedure from step 1.
To check settings
Press CLOCK/TIMER to select "©REC". Q
Two seconds later, the display will change in the following order.
CD
Recording start time
® Recording end time
(D Recording source
You can check settings even when power is OFF.
To enjoy the desired source after the timer setting is completed.
Even if you change the music source, the timer recording will start
with the preset condition.
1. Following step 6, turn ON the power and start playing the desired
source.
2. Press POWER to standby mode after enjoying the plav, and
confirm a tape is inserted in deck 2.
Turning the timer ON/OFF
As long as "®REC" is displayed, the record timer will come OX
everyday as set.
You can turn the timer ON/OFF by pressing "©PLAY/©REC" while
power is OFF.
Remember that when "®REC" is displayed, the timer is ON. When
not displayed, the timer is OFF.
mm
• If the power is ON, the timer will not function. The system must
be in the standby mode.
• If you switch the power to the standby mode while the record
timer is functioning, the OFF time setting will not be activated.
• If AUX is selected as the source, when the timer comes ON, the
system will turn ON, will engage "AUX" as the source and will
start recording. If you want to record from the connected
component, set the component's timer to the same time. (See the
instruction manual that came wdth the component.)