Panasonic NV-F65EA - Manual (Page 40)

Dubbing (copying) from one video cassette to another.
AUDIO VIDEO
Preparation
•Make the necessary connections as shown in the connec­
tion diagram.
• Press the VTR On/Off Switches to turn both VTRs on.
•Set the Input Signal Selector to “Line/Audio”. (Recording
VTR)
•Adjust the audio recording level as described on page 24,
(Recording VTR)
• Make sure that the Noise Filter/Edit Selector of both the
recording and playback VTRs (if equipped) are in the
“EDIT ON’’ position. Set these switches to “OFF” for
ordinary use of the VTRs.
(The Noise Filter/Edit Selector is on the front panel.)
O Place the recorded cassette in the playback VTR and a
blank video cassette with the erasure prevention tab
intact in the recording VTR.
@ Press the Record Button (•) on the recording VTR.
@ Press the Play Button (►) on the playback VTR.
^ Press the Stop Button (■) on both VTRs to stop the
dubbing.
•To assure smooth, noiseless cuts when interrupting
the recording, always use the Pause/Still Button
(II).
•To obtain smooth cuts when starting the recording
from the stop mode:
1. Play back the last part of the previously re­
corded material to confirm its ending point, and
then press the Pause/Still Button (II),
2. Press the Record Button (•).
(The VTR is still in the pause mode.)
3. To start recording, press the Pause/Still Button
(II) again.
•The picture quality of a re-recorded tape is not as
good as that of the original.
( 40 )