Panasonic NV-F65EA - Manual (Page 42)

INSERT EDITING
When this type of editing is done, the picture and the sound
are recorded on the tape as shown below. However, if no
new sound is input, the original sound remains only on the
“normal” audio track of the tape because the original Hi-Fi
sound will always be erased during insert editing.
By performing insert editing together with audio dubbing,
the sound on the “normal” audio track can also be replaced
at the same time.
Video and Audio Track Recording Pattern
. “Normal” Audio
(niiinurnTiy[umm']iiimiiuiyjimriui!iimiiiuiiiin^ Track Original
Sound
" Video Tracks
(Inserted Picture)
Hi-Fi Audio Tracks
(Inserted Sound)
Preparation
•Insert a video cassette with the erasure prevention tab
intact.
•When performing insert editing from another VTR, set the
Noise Filter/Edit Selector to “EDIT ON”.
•Set the Input Signal Selector according to the type of
insert editing to be performed.
“Line/Audio"; When inserting picture and sound from
equipment connected to the Video Input
Socket and the Audio Input Sockets on the
rear of this VTR.
“Tuner”: When inserting scenes from a TV pro­
gramme.
^ Press the Play Button.
^ Locate the tape position where you want the insert
editing to end, and press the Pause/Still Button to put
the VTR into the still playback mode.
0
Press the Reset/Index Button (Remote Controller) to
reset the Tape Counter to “0:00.00”.
O Press the Memory/Repeat/Search Button on the
Remote Controller so that the Memory Indicator “M”
mark will light up.
^ Perform review playback to locate the tape position
where you want the insert editing to start, and press the
Pause/Still Button to put the VTR into the still playback
mode.
O Press the Insert Editing Button.
(The Insert Editing Indicator lights up.)
If you want to replace the sound on the “normal” audio
track, too, press the Audio Dubbing Button.
(The Audio Dubbing indicator lights up.)
Q After the picture to be inserted is prepared, press the
Pause/Still Button (II).
(The insert editing will start.)
•The insert editing will end at the point where the Tape
Counter indicates “0:00.00”, and the editing VTR will
stop in the still playback mode.
Flaybadk of a Taf^ on Which Insert Editing Was
Petiormed
The sound inserted during insert editing is recorded on the
Hi-Fi sound tracks (STEREO, LEFT, RIGHT). If the normal
sound track is selected, the original sound before the insert
editing will be heard. Select the desired sound with the
Audio Output Mode Selector (Remote Controller).
Hi-Fi/Normal Mix Switch
Set this switch to “On”, if you want both the “Hi-Fi” sound
and the “normal” sound to be played back mixed together.
•The mixed sound may not be very clear.
Always set this switch to “Off”, except when playing back
a tape on which the insert editing or audio dubbing was
performed.
•The picture quality of an inserted part is always
somewhat inferior to that of the original.
•Avoid performing insert editing repeatedly on the
same part of the tape because the picture quality of
that part becomes inferior.
•The inserted picture may contain slight colour noise
or the colours may be unstable.
•Do not press the Memory/Repeat/Search Button
during insert editing. If it is pressed, the Memory
Indication “M” will disappear, and the insert editing
will not end automatically at the preset editing end
point.
•It is not necessary to operate the Tape Speed
Selector.
( 42 )