Panasonic RX-ES50 - Manual (Page 11)

Mstemng to the Radio
CD/rUNE/TIME as. T
5
2 1 BAND
POWER
m MODE/BP
O
Press POWER.
{Only when the batteries are used for the power supply)
For United Kindgom
cnmjNEmME
Press BAND to display “LW”,
“MW” or “FM”.
LW-^MW^FM
(The display changes each time the but­
ton is pressed.)
I For Australia and New Zealand]
Press BAND to display “AM”
or “FM”.
(The display changes each time the but­
ton is pressed.)
F M 8150
Press ►>!/+ or N^/“
(TUNING + or — on the remote
control) to select the station.
/+: The frequency is increased.
K^/-: The frequency is reduced.
Automatic tuning:
Keep ►►{/+ or
depressed until
the frequency display starts to change. A
station with good reception is automati­
cally selected and the selection process
then stops.
To stop automatic tuning, press ►►]/+
or HM/“ again.
P
08. to
Lights when a station is
tuned in properly.
Adjust the antenna.
lAM(LW/MW)i
When the batteries are used for the power supply, pressing POWER
on the remote control cannot turn the unit on.
GS2]
•Pressing BAND will automatically turn the unit on and receive the
broadcasts which is previously tuned (only AC power is supplied).
•The automatic tuning may stop without a station having been tuned
in when interference is encountered on neighboring airwaves, in
such a case, tune in a station by tapping ►►!/+ or
•Radio broadcasts may be hard to receive in a moving vehicle or
building because their signals are weak, in such cases, use the unit
near by a window.
When FM stereo reception is too noisy
(Available only from the remote control)
Set the sound to the monaural mode to reduce the noise.
FM MODeBP
Press FM MODE/BP.
The I MONO I display appears.
To return to stereo sound, press FM
MODE/BP again to turn off the i mono . I
display.
11