Panasonic RX-ES50 - Manual (Page 23)

•PLAY
• ■ R£C I
TIMER
3 -®* 4 -® 6 1*7
CLOCK/
2 *3
• PLAY
' *REC
satt /C power )
O
Prepare for recording.
1. Load the tape with the side on which
the recording will start facing up.
2. Select the broadcast station,
(See pages 11 and 12.)
3. Press REV MODE to select the re­
verse mode (see page 16).
If you do not want to hear any sound
while recording, turn down the volume.
(This will not affect the recording level.)
Press TIMER to display “REC’*.
ON^REC^OFF
t__________ I
(The display changes each time the but­
ton is pressed.)
If “TIMER-REC" indicator does not
tight:
Make sure that you have set the clock
(see page 7).
Lights.
f 11 025 nDU
Press POWER to turn the unit
off.
DD
“TIMER-REC” flashes during the pro­
grammed time.
Flashes.
F 8^0
To release the timer function:
(only when the unit is on)
Press TIMER to turn "OFF’ display on.
The timer will operate on the time you have set, if you press TIMER
again so that the TIMER-REC" indicator lights.
To check what has been programmed:
Press ADJUST when the unit is off and TIMER display on.
The display changes automatically as follows:
1. Programmed time
2. Programmed station
3. Programmed volume level
4. Original display
To enjoy play after programming: (after step 6)
1. Start playing the desired sound source.
2. After play, turn the unit off before timer recording starts.
•Be sure to turn tape direction indicator toward desired direction
before you turn the unit off.
•Even if you change the volume level or sound source, whatever
was programmed is restored at the recording time.
Using the timer at the same time every day:
First check that TIMER-REC appears on the display and then turn
the unit off.
Lights.
F n BBSO
To change the station to be recorded:
Press TIMER to turn off the “TIMER-REC” display, and then perform
steps 5 to 7.
To stop the timer in mid>operation:
Turn the unit off.
The timer wifi not operate if the unit is on.
23