Analogue Solutions Vostok Deluxe - Manual (Page 20)

Vostok Deluxe
20 Circuits – Main PANEL | Analogue Solutions
This control sets the time it takes for the pitch to change from one note to another. When a new
voltage is set to change the pitch of the VCO, is will glide from the old note to the new note.
When set to zero, then there is no glide (portamento), and pitch changes will be instantaneous.
Gradually turning clockwise increases the time.
LEVEL control
This is an attenuator for any signal fed into the CV2 modulation input socket.
WIDTH control
The Width changes the duty cycle/pulse width of the square wave output. This changes the tone of the
Square Wave. Note, this control is not an attenuator for the PW CV socket described later.
LEVEL (saw and square) control
This is an attenuator / output level control for the Saw and Square wave form audio outputs.
SYNC In (VCOs 1 and 3 only)
It is possible to reset the waveform using an external signal. Normally audio from another VCO would
be patched into here. Then when the pitch of the VCO is changed, interesting new harmonics can be
heard.
CV1 socket