Analogue Solutions Vostok Deluxe - Manual (Page 9)

Vostok Deluxe
Analogue Solutions | Safety Instructions 9
PREVENTING DAMAGE TO OTHER CONNECTED DEVICES;
Vostok has a very high dynamic range. It is capable of produce loud signals of very high and sub-sonic frequencies that could blow
inadequate speakers if played too loud. It is recommended that input levels to external equipment (mixers, amp's etc.) are kept low when first
connected, and then slowly increased to a useable level.
MAINTENANCE INSTRUCTIONS
Any cleaning of the Vostok case should be done with a clean lint-free cloth. DO NOT USE SOLVENTS OR CLEANERS, as this will deteriorate
the exterior appearance of the equipment.
MOUNTING
Mounting does not mean 'place on the wall' or 'to make love to' in this instance. Place Vostok soundly on any stable surface so he cannot fall
off or over, causing it or yourself injury.
POWER
The unit must be connected to the mains using an earthed and fused IEC power lead. Ensure the voltage indicated on the rear panel matches
your mains outlet. It will be factory set to either 115V (USA) or 230V (Europe). There is a Voltage select switch inside, but it is advised this is
only changed but a qualified electronics engineer.
SIGNAL TO NOISE / PITCH SCALING