Talkswitch M600I - Manual (Page 65)

M600i Control panel 65
This is the Internet version of the user guide. © Print only for private use.
Outgoing mail port – normally 25. Use
port 25 unless your email service provider
specifies something else.
Use MIME encoding – MIME encoding is
a standard that allows non-textual
information (for example graphics) and
accented characters to be sent in email
messages.
Setting up MMS manually
To set up MMS manually, first create an
Internet account for MMS, and then proceed
with the actual MMS settings. To edit existing
MMS accounts, follow the same procedure.
Control panel
Tools > Control panel is the location for all the
main settings on your phone that are system-
wide and often affect more than one
application. This is where you go to initially
set up your phone, and to change the settings
at any point after that.
Note: Some settings can be locked or hidden
by your operator.
Call settings
Accept calls
Select Tools > Control panel > Call settings >
Accept calls to specify who should be able to
reach you, and who should not, by setting the
accepted callers.
Controls tab
Specify whether your phone should reply by
sending busy signal or by hanging up.
Accept calls from menu
All callers – everyone calling you can
reach you.
Listed callers only – only persons (phone
numbers) that you have entered in the
accepted callers list can reach you.
Contacts – only persons in your Contacts
phonebook can reach you.
Speed dial – only contacts from your
Speed contacts can reach you.
No-one – no one can reach you.
List tab
Make a list of accepted callers. Select Add and
then select from Contacts , or enter a name and
a number.