Talkswitch M600I - Manual (Page 75)

M600i Control panel 75
This is the Internet version of the user guide. © Print only for private use.
automatically turn the backlight off to save
power. If you have set Backlight to
On , you
can still save power by selecting Power save
enabled . This will make the screen go blank
after a period of inactivity.
Active after determines how long after you
stop using the phone the screen should go
blank.
Screen saver
Select Tools > Control panel > Device >
Screen saver to select a screen saver. You can
select the default screen saver, a picture or a
folder of pictures to be used as a slide show.
Sounds & alerts
Ringtones
Select Tools > Control panel > Device >
Sounds & alerts > Ringtones to choose
ringtones for incoming voice and data & fax
calls in the drop-down menus. Tap and drag
the volume slider, or rotate the Jog Dial, to
adjust the ringtone level. To preview a sound
tap
. If you select Increasing ring the ring
signal will start out low and gradually increase
in volume.
You can further personalize your phone by
assigning different ringtones to different
contacts, see Adding a personal ringtone to a
contact on page 31.
Message alerts
Select Tools > Control panel > Device >
Sounds & alerts > Message alerts to select
sounds to be played when you get different
kinds of messages. If you select
Display
notification , a dialog will be displayed on the
screen when a message arrives.
Alarms
Select Tools > Control panel > Device >
Sounds & alerts > Alarms to select sounds and
adjust the volume for calendar and clock
alarms. Alarms require that the phone is turned
on. If you want to hear alarms but not be
disturbed by incoming calls or messages, set
the phone in Flight mode.
Vibrating alerts
Select Tools > Control panel > Device >
Sounds & alerts > Vibrating alerts and then
select for which events the phone should
vibrate.
On if silent means the phone will
vibrate only when it has been set to silent
mode. For more information, see Silent mode
on page 20