Cisco 3825 User Manual
Page 56
3-6
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Chapter 3 First-Time Configuration
Configuring Global Parameters
Step 3
Enter a hostname for the router (this example uses 3825-1):
Configuring global parameters:
Enter host name [Router]: 3825-1
Step 4
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when
viewing the configuration:
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: ciscoenable
Note
When you enter the enable secret password, it will be seen while you type the password. After entering
it, it becomes encrypted in the configuration.
Step 5
Enter an enable password that is different from the enable secret password. This password is not
encrypted (less secure) and can be seen when viewing the configuration:
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: ciscoenable
Step 6
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports
other than the console port:
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: ciscoterminal
Step 7
Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [yes]:
Community string [public]: public
Step 8
The summary of interfaces is displayed. This list varies, depending on what network modules, if any, are
installed in your router.
Current interface summary
Any interface listed with OK? value “NO” does not have a valid configuration
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/0
unassigned NO unset up up
GigabitEthernet0/1
unassigned NO unset up up
Step 9
Specify the interface to be used to connect to the network management system.
Enter interface name used to connect to the
management network from the above interface summary: GigabitEthernet0/0