ChemoMetec NC-200 - Manual (Page 27)

5 Operation of the NucleoCounter
991-0203 Rev. 1.1 Sep. 2012 13
5 Operation of the NucleoCounter
5.1 Ready mode
Once the NucleoCounter NC-200 and the NucleoView NC-200 software are ready, analysis
can begin. In the NucleoView NC-200 software, the browse menu can be used to select the
protocol to be performed. Once selected, the run button on the front of the instrument
(see Figure 4) or the run button in the software can be used to execute the analysis.
Figure 8 NucleoView NC-200
5.2 Analysis with the cassettes
To analyze with a cassette:
1. Load the cassette with an appropriate sample according to the protocol used
2. Place the cassette into the cassette fixture and close the lid
3. Press the Run
3
button.
After analysis the cassette is removed from the fixture and disposed of as biological waste
according to national or regional laws or regulations regarding the nature of the mixture it
contains.
3
Before this action the correct protocol has to be selected in the NucleoView NC-200
software.
Browse for
protocol