Eowave eobody 2 HF v1.2 - Manual (Page 12)

Eobody2HF / Eobody2HF editor
Eobody2HF and your computer
Factory settings
Factory settings are controllers 1 to 16 on MIDI channel 1.
1. Select Eobody2 MIDI port
Eobody2 uses the MIDI protocol to transfer data, that means it is com-
patible with almost every MIDI software.
First, you need to select “eobody 2” in the midi port scrolling menu.
The factice LEDs in & out will light up when receiving/sending mes-
sages.
2. Dump all current parameters from Eobdy2HF memory to your com-
puter by clicking on “dumpall”
3. Adjust the analogue inputs parameters settings you need. Refer to
the following section for a detailled description of each feature.
4. Set the number of active inputs to avoid unwanted messages and to
increase the response speed.
5. Click on “savemem” to save parameters into the Eobody2HF inter-
nal memory.
6. “Initall” will restore factory settings when confirmed by a click on
savemem.
7. Rereadmem will reload last saved memory
12