Eowave eobody 2 HF v1.2 - Manual (Page 19)

Configuration map for analogue inputs
Eobody2HF / Configuration map for analogue inputs
Type of message Res. Value Hi Low
CC - Control Change 7 bits CC value
CC - Control Change 12 bits CC value
Note - Note on trigger 7 bits note number higher threshold lower threshold
PC - Program Change 7 bits PG value higher threshold lower threshold
PB - Pitch Bend 12 bits
PB - Pitch Bend 14 bits
ATm - monophonic aftertouch 7 bits
19
VIII. Sensors compatibility
Sensor compatibility
Eowave sensors designed for Eobody2HF have been developped to get the best results from the sensor.
Eowave does not warrantee the use of sensors from other brands or “handmade”.
Sensor connections compatibility
If you already have some Eowave sensors with jack 6,35’’connectors, you may build an adapter jack 6,35’’ to 3
pins. You can also purchase one from Eowave.
Sensors compatibility with 3,3V
Note that some active sensors requiring more than 3,3V, such as infrared sensors, cannot be used with the
Eobody2HF. Check the power consumption of the sensors before using them.