CREATIVE 4X CD-ROM Drives GCD-R542B - Manual (Page 15)

Knowing Your CD-ROM Drive 1-6
CD Audio Connector
The CD Audio Connector allows you to direct audio output from your
CD-ROM drive to your audio card when it is connected using a CD
audio cable.
Master/Slave Jumper
The Master/Slave Jumper (see Figure 1-6) allows you to set your drive
as the Master or Slave drive. When you connect more than one drive,
you must set your drive to be either a Master or Slave drive (see the
section “Connecting Additional Drives” in Chapter 4). The jumper
labeled CS is reserved and should not be used.
IDE CD-ROM Data Connector
The IDE CD-ROM Data Connector allows data transfer between your
CD-ROM drive and various devices when connected using a data
cable. These devices include your audio card (with an IDE interface),
IDE CD-ROM interface card, and hard disk controller card.
Power-in Connector
The Power-in Connector allows electrical power to be directed from
your PC to the drive when connected using a power cable.
Figure 1-6: Master/Slave Jumper.