CREATIVE 4X CD-ROM Drives GCD-R542B - Manual (Page 32)

Setting Up Your CD-ROM Drive 2-17
6. Slide the drives back into place and fasten them to your system
as shown in Figure 2-23.
7. Switch on your system.
8. Proceed to install the software.
Installing the Software
The following instructions show you how to install two drivers
required to control your CD-ROM drive and an application that allows
you to play audio CDs.
To install the software:
1. Insert the CD-ROM Installation Disk into drive A or B of your
computer.
2. Type A:INSTALL (or B:INSTALL) and press <Enter>.
3. Follow the instructions on the screen to complete the
installation.
If you are connecting your drive to the hard disk
controller card, select 1F0 for the I/O address.
Figure 2-23: Fastening the drives to your system.