CREATIVE 4X CD-ROM Drives GCD-R542B - Manual (Page 59)

Resolving Hardware Conflicts B-3
3. Place the jumper block on the interface card to select the
desired base I/O address as shown in Figure B-1 . A jumper
block is a removable plastic hood that fits over a pair of pins.
4. Run CDSETUP or the installation program to update the
setting in your CONFIG.SYS file’s SBIDE.SYS statement.
For more information on CDSETUP, refer to the section
“Running CDSETUP” in Chapter 4.
5. Reboot the system for changes to take effect.
Figure B-1: IDE Port settings for the IDE CD-ROM Interface.