CREATIVE 4X CD-ROM Drives GCD-R542B - Manual (Page 20)

Setting Up Your CD-ROM Drive 2-5
6. Insert your CD-ROM drive into the vacant drive bay as shown
in Figure 2-6.
Do not slide the drive completely into the vacant drive
bay. Leave some space at the rear so that it is easier for
you to connect cables to your drive.
You may need to use some force to insert your
CD-ROM drive into your drive bay. However, please
refrain from excessive force as this may damage your
drive or other devices on your system.
Connecting Cables to Your Drive’s Rear Panel
To connect all the necessary cables to the rear panel of your CD-ROM
drive:
1. Locate an unused power cable from your system.
A power cable can be located from your system’s power supply
unit. The power supply unit is located at the right hand corner
on most systems.
Figure 2-6: Inserting your CD-ROM drive.