Hangar 9 Alpha 40 ARF Trainer - Manual (Page 39)

39 Hangar 9 Alpha 40 ARF Assembly Manual
 Step 5
Use a #1 Phillips screwdriver and the screws provided with
the servo to secure the aileron servo in the wing.

Step 6
Use a hobby knife to cut a 1/4-inch (6mm) piece from the
safety tubing. Slide the tubing onto a nylon clevis. Thread the
clevis 10-turns on a 6-1/8-inch (155mm) threaded pushrod.
 Step 7
Use a ruler and measure 4 3 /
8
-inch (111mm) from the pin in
the clevis. Use a felt-tipped pen to mark the pushrod wire. Use
pliers to make a 90-degree bend in the pushrod wire as shown.
 Step 8
Measure 3/8-inch (10mm) up from the bend and use
diagonal cutters to trim the pushrod wire as shown.
 Step 9
Repeat Steps 6 through 8 to make a second aileron
pushrod wire.

Step 10
Remove the servo horn from the aileron servo. Use side
cutters to remove the two shorter arms from the servo horn.