Hangar 9 Alpha 40 ARF Trainer - Manual (Page 41)

41 Hangar 9 Alpha 40 ARF Assembly Manual
 Step 2
Slide the wing tube into the wing panel as shown. The wing
tube will only slide in halfway, so do not force it in any
further than it will slide easily.
 Step 3
Slide the remaining wing panel onto the wing tube.
 Step 4
As you slide the wing panels together, make sure the
aluminum pin at the back (trailing edge) of the wing slides
into the hole of the receiving wing panel. Slide the two wing
panels tightly together so there is no gap between the two.
 Step 5
Use the supplied clear tape to secure the joint between the
two wing panels. Make sure to apply the tape to both the top
and bottom of the joint.
 Step 6
Connect the clevises from the aileron pushrods to the aileron
control horns.

Step 7
Plug the aileron servo into the extension coming from the
aileron port of the receiver. Turn on the radio system and
center the aileron stick and trim. Use a ruler to check that the
aileron are in alignment with the bottom of the wing. If they
are not, thread the clevis in or out as necessary to align the
aileron and wing. Make sure to align both aileron at this time.