Hangar 9 Alpha 40 ARF Trainer - Manual (Page 40)

40 Hangar 9 Alpha 40 ARF Assembly Manual
 Step 11
Use a pin vise and 5/64-inch (2mm) drill bit to enlarge the
holes in the servo arm that are 1/2-inch (12mm) from the
center of the horn as shown.
 Step 12
Plug the aileron servo into the extension inside the fuselage.
Turn on the transmitter and center the aileron stick and trim.
Attach the servo horn to the servo using the screw provided
with the servo and a #1 Phillips screwdriver.
 Step 13
Connect the aileron linkages to the holes of the servo horn
that were enlarged in the previous steps. Use the pushrod
snap links for this step.
Wing Assembly
Required Parts
Wing panel (left and right) Aluminum wing tube
Clear tape
Note : The following covers the assembly of the wing
without the use of glue. The wing, when joined in this
method, is very strong and does not need to be glued
together. You will want to purchase additional clear tape
if you plan on breaking the wing down into two pieces
for transportation purposes.
 Step 1
Locate the items necessary to join the left and
right wing panels.