Inovonics FA104 User Manual
Page 10
© 1994 INOVONICS Corporation
6
LIT-FA104-USER 14-Nov-95
Programming FA416, FA416D and FA464 Receivers
Press
ENTER to program a point or to modify settings.
Press
!
to go to DELETE POINTS menu option or
"
to go to OUTPUT SETUP.
Enter point number from keypad. Press ENTER.
(Note: nn=16 or nn=64, depending on receiver.)
Is the external transmitter switch loop Normally Open or Closed?
Arrow keys toggle between N/O and N/C.
Is a 2.2K end of line resistor being used?
Arrow keys toggle between YES and NO.
Is the FA200W widegap magnet contact being used?
Arrow keys toggle between YES and NO.
How often should transmitters send supervisory data?
Arrow keys toggle between UNSUPERVISED,
10, 30, or 60 SECONDS and 5, 30 or 60 MINUTES.
Which output should this point activate?
Arrow keys select desired output.
If the selected output has been previously assigned as a global fault output, the programmer will prompt for
confirmation:
It is recommended that the output be redefined as an alarm, or
that the point be assigned to another output. Arrow keys toggle
between YES and NO.
Press ENTER to proceed with transmitter programming.
or press A to go through transmitter options again.
Connect transmitter and press transmitter reset to program device, or press
A to save program information, activate the point and select a new point
number, or press EXIT to save program information without activating the
point. One of the following displays will appear:
If a transmitter is connected, display indicates successful transmitter
programming sequence. Display remains for about 3 seconds, then
returns to the point number selection screen.
If special key A is pressed, the point is saved and activated, even
though no transmitter has been programmed. This may be
necessary when replacing receivers or when using the FA100.
If EXIT is pressed, point program information is saved without
activating the point.
POINT NUMBER:
ENTER #(1 to nn)
CHECK-IN TIME
!
60 SECONDS
"
OUTPUT TO USE:
!
OUTPUT 1
"
OUTPUT n GLOBAL
CONFIRM?
!
YES
"
USE INTERNAL
CONTACT:
!
NO
"
END OF LINE
RESISTOR:
!
NO
"
EXT SWITCH TYPE
!
NORM/OPEN
"
Press ENTER to
!
PROGRAM POINT
"
Program
Points
ENTER TO PROGRAM
"A" to REVIEW
CONNECT TX+RESET
OR PRESS "A"
POINT NUMBER nn
TX PROGRAMMED
POINT NUMBER nn
POINT ACTIVATED
POINT NUMBER nn
PROGRAM SAVED