Inovonics FA104 User Manual
Page 11
© 1994 INOVONICS Corporation
7
LIT-FA104-USER 14-Nov-95
Programming FA416, FA416D and FA464 Receivers
Press ENTER to delete a point. Programming remains in memory, but the
receiver will not look for the point. To reactivate the point, go to Program
Points. Press
!
to go to CLEAR FAULTS menu option or
"
to go to
PROGRAM POINT.
Enter point number from keypad. Press ENTER.
(nn = 16 or nn = 64, depending on receiver.)
At this point the programmer requests confirmation:
Press
ENTER to accept answer in next line.
Arrow keys toggle between NO and YES.
Faults may be registered during programming and operation.
Press ENTER to clear latched fault outputs.
Press
!
to go to TEST OUTPUTS menu option or
"
to go to DELETE
POINT.
Press
ENTER to accept answer in next line.
Arrow keys toggle between YES and NO.
Press ENTER to test outputs.
Press
!
to go to POINT STATUS menu option or
"
to go to CLEAR
FAULTS.
Press ENTER to turn selected output on and off.
Press
!
or
"
to select a different output.
Note: The FA416 has 4 outputs, plus the fault output. The FA464 has 16 outputs, plus the fault output.
Creating Zones with the FA104: By assigning transmitter alarm conditions to specific alarm outputs, it is
possible to differentiate between types of alarms, areas of alarms, etc. For example, suppose an application in a
small business requires 10 holdup buttons, 1 fire exit door and 3 removable pendants. Program outputs 1, 2 and
3 to be active on alarm and program the FA200s attached to the holdup buttons to use output 1. Assign the fire
exit point to output 2 and the pendants to output 3. Configure the system to monitor low batteries and tampers at
output 4.
ARE YOU SURE?
!
NO
"
ARE YOU SURE?
!
YES
"
ENTER to TOGGLE
!
OUTPUT 1
"
Press ENTER to
!
DELETE POINT
"
Press ENTER to
!
CLEAR FAULTS
"
Press ENTER to
!
TEST OUTPUTS
"
Test
Outputs
Clear
Faults
Delete
Points
POINT NUMBER:
ENTER #(1 to nn)