Inovonics FA104 User Manual
Page 12
© 1994 INOVONICS Corporation
8
LIT-FA104-USER 14-Nov-95
Programming C404 Slave Receivers
with the FA104 Executive Programmer
Following are descriptions of menu and option displays. Main menu headings are POINT STATUS, RECEIVER
SETUP, PROGRAM POINT, and DELETE POINT.
When the FA104 is first powered up, the display briefly shows software information, then shows the logo display,
including receiver type.
To enter programming mode, enter the access code. Default access code is 0000. The display will show:
Press ENTER to see signal strength and current point status.
Press
!
to go to RECEIVER SETUP menu or
"
for DELETE POINT.
The first line shows point status, including a low battery symbol. The
value beside the GOOD SIGNAL or WEAK SIGNAL is dBm above
receiver threshold level, from -99 (weak) to -65 (strong).
Press ENTER to review or to modify receiver settings.
Press
!
to go to PROGRAM POINT menu or
"
for REVIEW POINTS.
System ID is encoded in all data transmissions to identify transmitters
to their respective receivers. Enter a code from 000 to 255.
Should the receiver monitor transmitters for inactivity?
Arrow keys toggle between YES and NO.
How long should the receiver wait for a supervisory signal to declare
points inactive?
Enter value from 1 to 254 minutes.
Change dealer access code, if desired.
Enter access code from 0000 to 9999. (0000 is default.)
WARNING:The C404 access code cannot be recovered or reset if
lost.
Set mode of all C404 ALARM outputs. Arrow keys select option:
FOLLOWER, LATCHING or MOMENTARY.
Press
!
or
"
to change option.
Note: This setting affects all of the C404's alarm outputs. The
C404 global fault output is always latching.
Press ENTER for
!
POINT STATUS
"
SYSTEM ID: 123
Point
Status
ACCESS CODE
0000
ALARM OUTPUTS :
!
FOLLOWER
"
MAX TX INACTIVE
TIME: 60 MINUTES
INOVONICS C404
SLAVE RECEIVER
SUPERVISE POINTS
!
YES
"
Press ENTER for
!
RCVR SETUP
"
Receiver
Setup
!#
1: ALM TMP B
"
GOOD SIGNAL (-nn)