Inovonics FA104 - Manual (Page 15)

© 1994 INOVONICS Corporation
11
LIT-FA104-USER 14-Nov-95
Appendix A
FA416 Receiver Parameters
Default
Active on
Output Condition Programmable Options
1 Alarm ALARM / ALARM+TAMPER / TAMPER /
2 Alarm LO BATT / INACTIVE / TAMP+LO BATT /
3 Alarm TAMP+INACTIVE / LO BATT+INACTIVE /
4 Alarm ANY TX FAULT / DISABLED
Transmitter Default
Condition Mode
Alarm Follower FOLLOWER / MOMENTARY / LATCHING
Inactive Follower
Tamper Latching
Low Batt Latching
Default Momentary Output time: 4 seconds 1 - 16 seconds
Default Receiver Parameters:
System ID: (randomly assigned at factory) 0 - 255
Point supervision: Yes Yes / No
Supervision window: 4 hours 1 - 99 minutes, 1 - 99 hours
Access code: 3446 0000 - 9999
Vision Plus compatible: No Yes / No
To reset a receiver to default parameters refer to Page 5 or see the receiver user manual.
Default Transmitter Parameters
Point # Contact Output Check-in
1 N/O 1 60 SEC
2 N/O 2 60 SEC
3 N/C 3 60 SEC
4 N/C 4 60 SEC
5 N/O 1 60 SEC
6 N/O 2 60 SEC
7 N/O 3 60 SEC
8 N/O 4 60 SEC
9 N/C 1 60 SEC
10 N/C 2 60 SEC
11 N/C 3 60 SEC
12 N/C 4 60 SEC
13 N/C 1 60 SEC
14 N/C 2 60 SEC
15 N/C 3 60 SEC
16 N/O 4 NONE
Note: Point 16 in Table 1 is programmed with no check-in. This configuration is often desirable for use with the
FA204 Pendant, permitting the pendant to be taken out of range without being reported inactive.