ALTANA Temp-Gard 12p Manual - Manual (Page 10)

9
4. Getting started
You can start a measurement
• with temp gard as data logger
- according to the standard settings for the
measurement parameters
- change of the measurement parameters
in the setup menu measurement parame-
ters
• by loading an Organizer
The measurement with the temp-gard as a data
logger is described in the following.
The measurement with an organizer loaded is
described in the temp-chart manual.
4.1 Starting the temp-gard logger
When the temp-gard logger is switched on, the
status of the setup settings will be displayed:
Screen 1: Firmware version, Certification and Cat.
No.
Screen 2: Ch xx: Probe name, press OK
Screen 3: No. of Probes – Measurement interval –
Trigger
Screen 4: Menu Connect the thermocouple probes
to the temp-gard instrument.
Start the measurement by pressing the start/stop
key.
Note: Make sure that the thermal barrier and the
heat sinks have cooled down completely after the
previous measurement.
Make sure that the heat sinks are inserted in both
halfs of the thermal barrier.
Place the temp-gard in the lower part of the ther-
mal barrier.
Make sure that all gaskets are clean and without
defects.
Place the temperature probe cables side by side
on the gasket of the thermal barrier and lock the
box with the upper part.
Attach the thermocouple probes to the object.
Getting started