Avlink YX-1044 - Manual (Page 7)

7
3.0.2 YX-1044 Rear Panels
1. Power Jack
2. Power Switch: To switch power ON or OFF the YX matrix host.
3. RS-232: Use the RS-232 connection cabel to connect the computer serial port (COM1 or
COM2) to the RS232 communication port of the YX matrix host. The computer can then be
used to control the YX matrix after installation of application software. The RS-232 port is a
9-pin female connector.
4. Switcher:
Pin1: Switch between RS-232 port and LAN port connection.
- Pin2: This Pin allows you to reset the IP value to 192.168.0.3. The steps are as below:
a. Please adjust the pin2 down and re-start YX-1044.
b. After the YX-1044 re-starts about 10sec, shut down your equipment.
c. Adjust the pin2 up, then power on YX-1044 again.
d. The IP address will be restored to the default value: 192.168.0.3
- Pin3: No definition.
Pin # UP DOWN
1 LAN RS-232
2 NORMAL IP DEFAULT
3 NC NC
5. LAN Port: Use the RJ-45 connection cable to connect the Internet and the YX matrix host.
The entire PC at the same network can control the YX matrix host through the LAN port.
6. IR2: Connect to the IR BOX .
7. Stereo Unbalanced Audio Output.
8. Digital Optical Audio Output.
9. Video Output.
10. Stereo Unbalanced Audio Input.
11. Digital Optical Audio Input.
12. Video Input.