AvMap EKPIV series - Manual (Page 28)

8
Fig. 3.5.3 - Data Window options
3.5.4 Setup data Fields
You can select the item to be displayed in each of the fields of the Data Window. The following
figure displays the options available. The fields selected for each window mode option (1-line, -
lines, etc.) are independent; therefore, you can select different fields for each window view.
> ‘MENU’ + “SETUP DATA FIELDS” + ‘ENTER’
After pressing ‘ENTER’, a box in the Data Window will be highlighted. Using the cursor key, select
the box to be edited and press ‘ENTER’. The OPTIONS box will appear (see previous figure)
allowing you to select the item to display in the highlighted is box. Highlight the desired item from
the list and press ‘ENTER’ to accept. You can then scroll to another box and proceed as above.
Once all boxes are set up, press ‘CLEAR’ to exit.
Fig. 3.5.4 - Setup Data Fields
Note
The Dest: Wpt Info option requires 3 vertical fields for display; therefore, you can only select this option in a top
field on the 3-line display or the top field in the HSI + Fields display. If you attempt to select this item in another
filed, the system will beep three times and revert to the previous selection mode. If you have the Dest: Wpt Info
displayed and would like to change to three different items, select the top of the Destination Info box. The first
filed will display the one you selected and the bottom two fields will display default items.