AvMap EKPIV series - Manual (Page 69)

69
14.2.4 Static navigation
A GPS-receiver can produce speed settings that are minimal when standing still. The Static
Navigation sets a threshold for the speed. When the speed received from the positioning device is
under 0.89 knots, the EKP-IV displays zero. The default setting is On.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “FIX SETUP” + ‘ENTER’ + “STATIC
NAVIGATION” + ‘ENTER’
14.2.5 Course Predictor
The EKP-IV will display a line with a circle at the end to indicate the position your aircraft will reach
at the set time, based on current direction of travel and speed. This is continuously updated to
account for changes.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “FIX SETUP” + ‘ENTER’ + “COURSE
PREDICTOR” + ‘ENTER’
Setting options are: OFF, INFINITE, 1 MIN, 3 MIN, 6 MIN, 10 MIN, 30 MIN, 1 HOUR,  HOURS.
The default setting is 10 MIN.
14.2.6 head Up Response
The Head Up Response is related to the Track-up mode of operation. When displaying the position
fix in Track-up, the setting selected here will enable the heading to vary +/- the degree selected
before the map is redrawn. A higher number here will result in less redraw time.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “FIX SETUP” + ‘ENTER’ + “HEAD
UP RESPONSE” + ‘ENTER’
Setting options are: +/-5, +/-10, +/-15, +/-45, +/-90. The default setting is +/-15.
14.2.7 Fix Circe Range
This function displays a circle of arbitrary range with the fix as its center on the moving map.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “FIX SETUP” + ‘ENTER’ + “FIX
CYRCLE RANGE” + ‘ENTER’
Use the cursor key to select the desired range.
14.2.8 GPS Restart timeout
This function enables to set a time range after which if fix is not present the GPS is automatically
restarted. If 0 Minutes are set, the function is not activated.
14.3 ALARM Set-UP
The EKP-IV provides alarm settings for various functions. Here you can set the system for your
navigational requirements.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “ALARM SETUP” + ‘ENTER’
14.3.1 Arrival Alarm Radius
Specifies the radius of a circle around the Waypoint of a Route: when your aircraft reaches a point
within this circle an alarm sounds and the Waypoint Arrival box appears on screen. To set this alarm:
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “ALARM SETUP” + ‘ENTER’ +
“ARRIVAL ALARM RADIUS” + ‘ENTER’