Crestron electronic TPS-TPI - Manual (Page 12)

Touchpanel Interface Crestron Isys™ TPS-TPI
Main Menu
The Exit and Run Program button verifies that all of the setup information has
been saved to EEPROM and displays the main page that has been programmed into
your system. The remaining buttons on the Main Menu open other menus, which are
discussed in subsequent paragraphs.
Calibration Menu
Calibration of the display is required if the active touch area of a button does not
coincide with the button's image. Select the Touch Screen Calibration button to
display the Calibration Menu, shown after this paragraph. The Calibration Menu
offers the choice to initiate calibration with the Perform Calibration button or
return to the previous screen with the Return button. Choose an option by touching
the correct button.
Calibration Menu
If you proceed to calibrate the display, the screen prompts you with the message
"Touch Upper Left +" nearly centered on the display. A cross hair (+) in the upper
left corner indicates the exact location. Touch the cross hair (+) in the upper left
corner of the screen to initiate calibration. Another message, "Touch Upper Right +",
appears on the display. Touch the cross hair in the upper right corner. Another
message, "Touch Lower Right +", appears on the display. Touch the cross hair in the
lower right corner of the screen to return to the Main Menu.
NOTE: When touching the screen during calibration, be as accurate as possible.
8 • Touchpanel Interface: Crestron Isys™ TPS-TPI Operations Guide - DOC. 5855