Crestron electronic TPS-TPI - Manual (Page 14)

Touchpanel Interface Crestron Isys™ TPS-TPI
can vary from 0 to 120, where 0 disables the timeout. DOWN and UP buttons
decrease and increase the timeout, respectively.
Panel Tracking
Panel tracking is a useful communication feature between displays when more than
one display exists on the network. Two buttons centrally located in the bottom row
of the Setup Menu control panel tracking. Button selection is indicated by red text.
When the Enable Panel Tracking button is selected, a given display maintains
communication in such a way that a page change to any display on the network
forces the same page change to all enabled displays. Panel tracking is disabled for a
given display when the Disable Panel Tracking button is selected. When disabled a
given display does not respond to page changes made to other displays on the
network. Panel tracking is factory set with the Disable Panel Tracking button
selected.
Ethernet
NOTE: The Ethernet button is displayed on the Setup Menu only if the
TPS-ENETL is properly installed.
NOTE: IP settings are necessary only if the TPS-ENETL is installed. Serially
connect a PC to the TPS-TPI via the RS-232 connector and refer to the details in the
latest revision of the TPS-ENETL (Doc. 5829).
Selection of the Ethernet button from the Setup Menu displays details such as the IP
Address, Subnet Mask, Def(ault) Router, IP Table, etc. For example, refer to a
sample display shown after this paragraph. The settings can only be viewed from this
screen. To enter commands to access/set all Ethernet configurations use the RS-232
connector and refer to the information in the TPS-ENETL Installation & Operations
Guide, as stated in the previous note.
Sample Display from Ethernet Button Press
Return
Select the Return button, located at the lower right corner of the Setup Menu, after
setup parameters have been set.
Interface Menu
The TPS-TPI communicates with a control system to activate other controls or to
display feedback from components within the system. The communication interface
must be correctly specified or communication will not occur. To set communication
10 • Touchpanel Interface: Crestron Isys™ TPS-TPI Operations Guide - DOC. 5855