Crestron electronic TPS-TPI - Manual (Page 19)

Crestron Isys™ TPS-TPI Touchpanel Interface
There are two buttons on the RGB Menu that influence the storage of format presets.
Use the Erase Selected Preset button to eliminate the stored format for the
highlighted preset. The Clear All Presets button eliminates the formats for all
presets. The TPS-TPI prompts the user for confirmation.
NOTE: If no presets are stored or the input does not closely match a stored preset,
the panel makes a 'best guess' for image settings.
The user has the option to manually select a preset for the incoming format or have
the TPS-TPI select one automatically. On the rare occasion, the user may want to
choose the Manual Select button to force a preset on an incoming format.
Otherwise, select the Auto Select button to have the TPS-TPI automatically search
through the preset formats for a match to the input signal.
Select the Return button, located at the lower right corner of the RGB Menu, after
RGB parameters have been set.
Video Menu
NOTE: The Video button is displayed on the Setup Menu only if the TPS-VIDL is
properly installed. Selection of the Video button opens the Video Menu from which
the user can adjust video settings.
The TPS-TPI can display video from up to two different video sources. Both of these
signals are automatically set up as NTSC or PAL, composite or S-Video. Selecting
the Video button, located to the right on the top row of the Setup Menu, displays the
Video Menu, shown after this paragraph.
Video Menu
Use this screen to select one of the video inputs and adjust the brightness, contrast,
saturation, and hue, if necessary. The user has the option to force the video image to
a certain mode (i.e., composite video or S-video) or switch modes automatically after
checking the image for colors. Use either the Composite Video or S-Video buttons
to manually control the mode. Composite video mode uses a single video signal for
luminance and chrominance. S-Video mode uses separate signals for luminance and
chrominance, which results in superior resolution and color fidelity. Use the Auto
Detect button for automatic control. The number (1 or 2) on the selected button
specifies the video input connector. Number 1 corresponds to the twisted pair
connector and number 2 corresponds to the BNC connectors. The text color of the
selected button is red rather than black.
Operations Guide - DOC. 5855 Touchpanel Interface: Crestron Isys™ TPS-TPI • 15