Carl Goldberg GBGA1089 - Manual (Page 12)

4. Place the wheel pant over the axle.
Install one wheel collar with set screw then the
wheel, finally the second wheel collar with set
screw.
Using thread lock, tighten the wheel pant to
the landing gear.
Center the wheel on the axle using the wheel
collars on both sides of the wheel.
12
Even
2. Hold the bottom of the wheel pant level with
the bottom of the landing gear.
Mark the wheel pant mounting hole locations
onto the wheel pant through the landing gear.
3. Drill a 1/8” hole and insert a 4-40 blind nut into
the hole from the inside of the wheel pant.
Using the 4-40 x 1/2” socket head bolts,
screw the wheel pants to the landing gear.
Tighten the 4-40 screws to seat the blind nuts.
Remove the wheel pants.
Wheel collars