Carl Goldberg GBGA1089 - Manual (Page 16)

16
7.
Mount throttle servo in the servo tray .
Note: Your installation may vary depending
on the engine used.
Install pushrod connector on your servo arm
and attach to the throttle servo .
8. Insert the .pushrod wire through the connec-
tor on the servo arm.
Locate the proper positioning of the throttle
servo arm. Then cut off the excess wire, keep-
ing some wire for future adjustments.
PUSHROD CONNECTOR
SNAP NUT
INSTALLING THE COWL
Collect the following items:
(1) Cowl
(4) 2mm x 5mm Philip head screws
(1) 4” x 12” clear plastic
1. Make a mark 2” back from the middle front
tabs on the fuselage sides in each of the white
stripes.
2” Back
Center of tab
2. Place the piece of clear plastic over the top of
the engine. The end of the plastic should
extend just past the cylinder head.
3. Mark where the engine contacts the plastic.
Remove the plastic and, using the moto tool,
cut out the engine area until the plastic fits
over the top of the motor and lies flat on the
fuse side. Then, tape the edges of the plastic
to one side of the fuselage.
4. Lift up the untaped side of the plastic and
remove the engine.
5.
Slide the cowl under the plastic.
CAUTION! WHEN CUTTING THE COWL, ALWAYS
WEAR PROTECTIVE EYE GEAR AND A LONG-
SLEEVE SHIRT. CHANGE CLOTHES AND WASH
AFTER CUTTING.
6.
Securely tape the cowl to the fuselage,making
sure that the cowl is 5-5/8” away from the fire-
wall. Once taped, measure the cowl again to
make certain its position has not shifted.
Trace the cut out on the clear plastic to the
cowl.