Carl Goldberg GBGA1089 - Manual (Page 5)

5
AILERON SERVO INSTALLATION
Note: The following pictures may not exactly match
the hardware you are using. Always check the radio
manufacturer's instructions when installing radio
equipment.
1. Collect the following items:
(16)Servo mounting screw (supplied with radio)
(4) Servos with rubber grommet & eyelets(sup-
plied with radio)
(2) 12” servo Extension (for the aileron servos).
(1) 30” string
(1) axle nut
IMPO RTANT! To ensure that any connections locat-
ed inside the wing will not come loose, either when
the wires are pulled, or during flying, always tape
them securely together with electrical tape.
2. Attach the aileron servo wire to the12" exten-
sion and securely tape the connection togeth-
er.
Tie the 30” string to the axle nut.
Tie one end of the string to the aileron servo
extension.
While holding the wing up on the root rib, drop
the other end of the string with the nut into the
aileron servo hole. Allow the nut to fall down
through the wing rib holes till it exits the cen-
ter root rib.
3. SLOWLY pull on the string until the end of the
12" extension comes out of the hole.
Tape the extension securely to the wing, so
that it will not slide back in while you are work-
ing.
Repeat these steps for the other aileron
servo.
The flap servos are done in the same manner
as the aileron servos without using exten-
sions.
4. Using the screws supplied with your radio,
screw the servos to the mounting plates in the
wings.
WING STRUT BRACKET INSTALLATION
1. C
OLLECT THE FOLLOWING ITEMS
:
(4) S TRUT MOUNTING BRACKET
(4) #2
X
3/8
SHEET METAL SCREW
2. Place a small drop of thin CA glue into the
wing strut mounting holes found in the bottom
of the wing above and below the aileron
servo.
Slightly bend the strut mounting bracket in the
middle.
3. Using #2 x 3/8 sheet metal screw, mount the
bracket so that it is pointing to the fuselage.